What's new in the Gallery?
Check This thread
Check This thread
Master Box Ltd. 1/24 scale figures
Moderators: Jim Bertges, Moderators
-
- Gone but not Forgotten
- Seam Filler
- Posts: 373
- Joined: May 31st, 2010, 10:01 pm
- Location: Liberty, Missouri
Master Box Ltd. 1/24 scale figures
I just bought "Thunder Spirit" (Native American girl warrior) at my local hobby shop It's produced by Master Box Ltd. (The Ukraine). Beautiful detail but what type of plastic is it ? I know this same company makes all kinds of military figures for dioramas. So... my question is what type of glue should I use on it ? One site says to use Revell Contacta Pro Glue. That glue can be ordered from Amazon but it's shipped from the United Kingdom with a 4-week delivery time. Any other ideas on a good glue to use that I can buy right here in the USA ?
Ellis K. in Missouri
-
- Squire of the Sprue
- Posts: 1468
- Joined: May 26th, 2012, 11:33 pm
- Location: Not the Moon.
Re: Master Box Ltd. 1/24 scale figures
My choice is Tamiya thin. Or, there is also Testors. Both are liquid glue for STYRENE plastics. Just apply sparingly because for one, it's thin and will run easily, and two, it's strong and over use can cause problems because this type of glue melts the plastic together. Practice with it first. Put the parts together then apply the glue with a small tipped brush. The Tamiya has its own fine tipped brush in the cap!
Hope this helps.
Carl-
Hope this helps.
Carl-
-
- Gone but not Forgotten
- Seam Filler
- Posts: 373
- Joined: May 31st, 2010, 10:01 pm
- Location: Liberty, Missouri
Re: Master Box Ltd. 1/24 scale figures
Thanks, Carl !
I have some of the Testors in the black squarish plastic bottle with the metal tube. I'll try it out ! That 1:24 figure sure is tiny !
I have some of the Testors in the black squarish plastic bottle with the metal tube. I'll try it out ! That 1:24 figure sure is tiny !
Ellis K. in Missouri
-
- Squire of the Sprue
- Posts: 1468
- Joined: May 26th, 2012, 11:33 pm
- Location: Not the Moon.
Re: Master Box Ltd. 1/24 scale figures
After 1/8, 1/6 or larger I'm sure 1/24 does seem tiny! I've never used that glue bottle like you have, it always kinda scared me. What I mean is if it's water thin it could deposit way too much glue and run all over. Remember don't let the glue get under your fingers because it WILL damage the plastic with bad finger prints. And that could damage the figures' detail. In fact it will.
Good look!
Carl-
Good look!
Carl-