3D printed Anguirus sculpted by Dopepope

[DinoMike]

I'm currently printing this bad boy, digitally sculpted by Dopepope. I've had my share of troubles with this print, none of which were due to the actual model, only my printer. Parts popping loose from the build plate, a nozzle clog... it's madness, I tells ya!

I'm printing this at the default FDM size, which is listed as 1:250 scale. I still have a way to go on getting the parts printed out. Since this photo was taken, I've printed and attached the base piece of the tail. The remaining tail part is currently printing. Then I have the last 2 sections of his carapace to print, his tail spikes, and lastly the 4 pieces of the base. FDM printed on an Artillery Sidewinder X2.

[DinoMike]

The tail parts and tail spikes are all printed and attached. All that's left for the main figure parts are the last 2 carapace pieces, then I start printing off the 4 base pieces.

[mrestfla]

dimensions? it's excellent!

[DinoMike]

dimensions? it's excellent!

Here's an earlier pic that I took with a tape measure in the frame.

[mrestfla]

after all the remaining pieces are finished, are you able to produce this monster fast? to be sold? price?

[DinoMike]

after all the remaining pieces are finished, are you able to produce this monster fast? to be sold? price?

Nope, sorry, no production run from me on this. The license on the digital file that I purchased doesn't permit it.

[DinoMike]

The trials and tribulations of 3D printing. I got a good start on the final part of the figure... and had a support fail. I'm having to start from scratch on this part.

[tay666]

That is a nice size. Gonna be a fun piece for sure.

[DinoMike]

That is a nice size. Gonna be a fun piece for sure.

Oh yeah! Gonna be a bit of a learning curve as compared to resin kits. Today I had to take a heat gun to the pieces and carefully melt off fine strings of PLA plastic that the nozzle left behind while printing. In some places, it looked like Anguirus had been in a fight with Kumonga. Most of the pieces fit together almost perfectly, but in some places my printer must have been a touch off, I'll need to fill some gaps, either with Vallejo plastic putty or epoxy putty and a texture stamp for a couple of larger gaps.

[DinoMike]

The figure itself is finished, I just need to print the base. In addition to the usual filler primer and sanding to hide layer lines, I need to fill a few pretty serious gaps. Looks like my printer isn't QUITE tuned properly.

[DinoMike]

A snag has developed. The base won't print properly. I went back and looked at the digital file in my slicer, and for some reason the center of the base is flat, but there's a wavy margin surrounding the flat center. From that margin, the base slightly curves upward toward the outer edge. That upward curve is causing problems, my printer is trying to print this really fragile mesh to support it, and failing every time. I've reached out to the company's tech support to see if they can flatten the bottom out. I doubt this is something DopePope did, as I have a few other kaiju files that he sculpted, and the base bottoms are flat on all of those.