Base was 3D printed with some sand texture applied - I needed something as minimal as possible because there's little room left in the display cabinet. Every square inch counts!
Anubis Warrior
Moderators: tay666, Moderators
Anubis Warrior
Bought this at the same time Kathy bought hers eons ago, but he's sat in 'almost done' hell for years. Decided to bite the bullet and get him finished this weekend. Fairly minimal paint job, mostly browns and golds. I discovered I'd misplaced his rear 'modesty panel' so I had to make a new one from some rolled out MagiSculpt.
Base was 3D printed with some sand texture applied - I needed something as minimal as possible because there's little room left in the display cabinet. Every square inch counts!
Base was 3D printed with some sand texture applied - I needed something as minimal as possible because there's little room left in the display cabinet. Every square inch counts!
-
bucketfoot-al
- Registered Seller
- Posts: 8053
- Joined: September 10th, 2005, 6:16 am
- Location: Back in The Lone Star State.
- Contact:
Re: Anubis Warrior
Nice recovery - beautiful base!!! 
Bucketfoot-Al
http://bucketfoot-al.tripod.com/DinoModels/
"You may all go to Hell. I will go to Texas."
-Davy Crockett
http://bucketfoot-al.tripod.com/DinoModels/
"You may all go to Hell. I will go to Texas."
-Davy Crockett
-
tay666
- Site Admin
- Posts: 18911
- Joined: December 8th, 2003, 11:20 am
- Location: Conneaut Ohio
- Contact:
Re: Anubis Warrior
Looks great!
Trevor Ylisaari
Check out My Prehistoric Scenes site and forum
"Nothing like a trail of blood
To find your way back home."
WANTED - Bat Rider - produced by Wraiths
Check out My Prehistoric Scenes site and forum
"Nothing like a trail of blood
To find your way back home."
WANTED - Bat Rider - produced by Wraiths
-
PROFESSOR JARROD
- Registered Seller
- Posts: 2689
- Joined: April 22nd, 2007, 9:53 pm