I purchased the files from CA Sculpts for a very reasonable 30 Euros. She comes as both unsupported and pre-supported/hollowed sub-assemblies in 1/6th scale and is big! The main body completely filled the height of my Elegoo Saturn right to the very last layer!
Everything printed fine, however the supports were perhaps a little over-zealous and removing them from some of the larger parts was a serious effort, even after soaking in hot water to soften them. The density was very high and whilst this help preserve the shapes of the under surfaces well, it also resulted in quite a lot of waste in the end.
Painting was fun - mostly airbrushed acrylics and then some judicial use of oils to blend and shade the significant borders between colours, and some other detailed shading on the flesh.
Thanks for looking!
