Hi All,
I am having a rough time with my HP-A+. It's been reliable for about three years but now I cannot seem to get normal pressure out of the AB. Paint and/or air just trickles out unless I jack it over 30 psi. I plug in a different AB and the pressure is fine.
So far I have:
1. replaced the air valve set
2. replaced the .2mm needle
3. Cursed at it
4. degreased it.
Any ideas????
thanks
scott
Iwata HP A+ HELP
Moderators: tay666, Moderators
-
monkey5150
- Bishop of Build Ups
- Posts: 2500
- Joined: May 17th, 2005, 12:28 am
- Location: newburgh NY so hide your wallet
Re: Iwata HP A+ HELP
Sent PM
-
NM 156
- Registered Seller
- Posts: 1237
- Joined: June 2nd, 2007, 4:31 pm
- Location: Monmouth County, NJ USA
Re: Iwata HP A+ HELP
Any chance of having response/info posted?
I have an HP A+ which is working fine, but any
info could be helpful in the future. Thanx
I have an HP A+ which is working fine, but any
info could be helpful in the future. Thanx
Matt K.
-
RickDTM
- Registered Seller
- Posts: 3833
- Joined: December 19th, 2003, 5:42 pm
- Location: Baltimore MD
- Contact:
Re: Iwata HP A+ HELP
Did you get this one working again Scott?
Check out my work at my Facebook art page: Rick Cantu's Paintwerks
-
ffolkes75
- Registered Seller
- Posts: 303
- Joined: January 26th, 2005, 2:48 pm
- Location: Rochester, NY
- Contact:
Re: Iwata HP A+ HELP
hope its been resolved...I had issues once with my HP-C+. same kind of deal. had to crank up the air...was getting uneven spray. turned out that even after multiple thorough cleanings...there was a slight build up of paint in the fluid nozzle. took it off...soaked it and cleaned it out and everything was back to normal.