What's new in the Gallery?
Check This thread

Resin printing question

Show off your in-progress builds! This is the place to post questions about building and painting your model kits and to share your latest techniques.

Moderators: tay666, Moderators

Post Reply
Message
Author
Albi

Resin printing question

#1 Post by Albi »

I'm not sure if this is the area for my question. I'm working on a model for an armor on blender that is coming out a little too thin when I test print it. I scaled it to be about 1.5 mm in thickness to accommodate some shrinkage. The armor is for a custom 1/12 figure. Has anyone here ever printed out stuff like this? And...should I make my pieces thicker? What do you guys think.

User avatar
Tim Fortuna
Registered Seller
Registered Seller
Wizard of Washes
Posts: 6739
Joined: December 20th, 2003, 12:01 am
Location: Winnipeg, Manitoba

Re: Resin printing question

#2 Post by Tim Fortuna »

Post some pics if you can, this sounds awesome.
Also, it couldn't hurt to try it a little thicker. If you have the resources to experiment that is.
"There are several sacred things in this world that you don't ever mess with. One of them happens to be another man's fries..." Louis Fedders

Post Reply