What's new in the Gallery?
Check This thread
Check This thread
Teeth Tips
Moderators: tay666, Moderators
-
RudeDogg1
- Registered Seller
- Seam Filler
- Posts: 387
- Joined: November 15th, 2014, 4:16 pm
- Location: Barnstaple, Devon, UK
Teeth Tips
Hi guys does anyonbe have any tips / hacks on putting the points back on resin teeth that have been lost to air bubbles? Aves is a pain in the butt that small
-
frankzilla
- Registered Seller
- Master of Masking
- Posts: 713
- Joined: May 7th, 2007, 1:56 am
- Location: Orlando,Florida
Re: Teeth Tips
Liquitex modeling paste or putty in a tube from Vallejo, Tamiya, etc. I have also used gel CA glue
-
NM 156
- Registered Seller
- Squire of the Sprue
- Posts: 1233
- Joined: June 2nd, 2007, 4:31 pm
- Location: Monmouth County, NJ USA
Re: Teeth Tips
Cutoff tips of round toothpicks and CA Glue.
If you have micro drill bits, they help alot to
make holes to glue into. This makes a base
to adhere the Aves to.
If you have micro drill bits, they help alot to
make holes to glue into. This makes a base
to adhere the Aves to.
Matt K.
-
RudeDogg1
- Registered Seller
- Seam Filler
- Posts: 387
- Joined: November 15th, 2014, 4:16 pm
- Location: Barnstaple, Devon, UK
Re: Teeth Tips
Sounds like a planfrankzilla wrote:Liquitex modeling paste or putty in a tube from Vallejo, Tamiya, etc. I have also used gel CA glue
-
scuzzfink85
- Bishop of Build Ups
- Posts: 3570
- Joined: May 13th, 2008, 2:18 am
- Location: Hell Mouth L.A
Re: Teeth Tips
Apoxie paste or acrylic gloss sealer in bottle ..
It really fills pin holes..
It really fills pin holes..
Nostalgia can be a bad thing, especially when you are led by it.
L.K . Marks 07.
My Kung Fu is the best..
Blind ignorance can not be solved or stopped for the problem at hand.
R.T 2021
L.K . Marks 07.
My Kung Fu is the best..
Blind ignorance can not be solved or stopped for the problem at hand.
R.T 2021
-
Big Daddy Dave H
- Registered Seller
- Seam Filler
- Posts: 256
- Joined: December 21st, 2003, 4:28 am
- Location: South Bend, IN
Re: Teeth Tips
3D resin and a UV light work great for this. Just one more benefit of being in the 3D end of the hobby. The clear also works great for eyes and teeth for a finish layer. The beauty of it on eyes is you can coat the entire eye first and cure it. Then you can go back and add a very realistic bump on top of the iris with a smaller drop of the clear resin and it cures in seconds with the light.